Money Saving: Make Significant Savings and Reduce Your Water Bills

Faucet perlators – bring significant savings on taps that are most commonly used. This action is achieved by mixing the air with the water flowing through the tap. Perlators are installed on sinks and washbasins, and in this way, besides reducing the water consumption, reduce the bill for the energy used to heat water.

By installing perlators the water flow decreases while the visual impression of the water jet remains the same.

In addition to saving water, the bill for the boiler water is also reduced.

Easy installation on faucets and showers.

Their maximum flow is 6 liters of water per minute.

To get the most out of their role, it is important that they are placed on spots  where the water runs out of steam (on sinks, dishwashers, washbasins, shaving, toothbrush …) as well as on showers.

Perlators are not intended to be installed on small low-pressure flow boilers (<15 l) because they could be damaged.

Unique flow control technology keeps water flow constant, regardless of inlet pressure (6 liters after 1 minute, when you wash your hands, or 9 liters after one minute of showering). Therefore, the use of water flow regulators do not only saves a lot of money, but also guarantees an even distribution of water.

To meet the required standards and regulations, flow regulators are placed on showers and taps. In commercial and institutional installations, the flow regulator improves the distribution of water and helps to save water and energy.

Using this system, you save water, energy, protect the environment, and meet the requirements of energy-certification of the facility (water flow to taps below 12 l per minute).

By replacing the existing tap sieve with perlators you can save 50%, in some cases up to 70% water, but you also save energy for hot water (gas, electricity, oil). By incorporating perlators, the water jet becomes richer due to air mixing allowing you comfortable use and does not diminish convenience.

The percentage of savings depends on the current flow of water per minute on your taps.

Through the sink taps the most frequent flow is 14-18 l / min. By installing the perlator, the flow rate is reduced to 6 l / min. Average shower flow is 15-20 l / min. By installing perlators the flow is reduced to 9 l / min.

Your daily need for shower water decreases by up to 60 percent due to sophisticated flow limitations, nozzles and added air.